D-Link DSL-G684T Manuale Utente Scaricare il pdf (Pagina 35)

At the end of the setup section we check if the SPI-to-UART bridge is initialized

successfully (SPI_Uart_Init()) and afterwards if wireless connection with the predefined

configuration is set up properly(autoconnect()).

3. void loop()

Void loop() is the section of the software that, as its name suggests, repeats over

and over again. This is the main part from which all external functions and procedures are

being called. For safety issues, just in case, 



the data from receiving register. After that we simply wait for a client to appear.

SPI_Uart_println("exit");

delay(500);

Flush_RX();

…

while(!Have_Client());

if(SPI_Uart_Init()) //Test SC16IS750 communication

{

Serial.println("Bridge initialized successfully!");

}

else{

Serial.println("Could not initialize bridge,

locking up.\n\r");

while(1);

}

autoconnect();

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 117 118

Nessun commento

D-Link DSL-G684T Manuale Utente Pagina 35